Amap -bq 7kb.org 1-800
Amap -bq 目标 端口
Amap v5.4 (c) 2011 by van Hauser <[email protected]> www.thc.org/thc-amap
Syntax: amap [-A|-B|-P|-W] [-1buSRHUdqv] [[-m] -o <file>] [-D <file>] [-t/-T sec] [-c cons] [-C retries] [-p proto] [-i <file>] [target port [port] …]
-A Map applications: send triggers and analyse responses (default)
-B Just grab banners, do not send triggers
-P No banner or application stuff – be a (full connect) port scanner
-1 Only send triggers to a port until 1st identification. Speeeeed!
-6 Use IPv6 instead of IPv4
-b Print ascii banner of responses
-i FILE Nmap machine readable outputfile to read ports from
-u Ports specified on commandline are UDP (default is TCP)
-R Do NOT identify RPC service
-H Do NOT send application triggers marked as potentially harmful
-U Do NOT dump unrecognised responses (better for scripting)
-d Dump all responses
-v Verbose mode, use twice (or more!) for debug (not recommended 🙂
-q Do not report closed ports, and do not print them as unidentified
-o FILE [-m] Write output to file FILE, -m creates machine readable output
-c CONS Amount of parallel connections to make (default 32, max 256)
-C RETRIES Number of reconnects on connect timeouts (see -T) (default 3)
-T SEC Connect timeout on connection attempts in seconds (default 5)
-t SEC Response wait timeout in seconds (default 5)
-p PROTO Only send triggers for this protocol (e.g. ftp)
TARGET PORT The target address and port(s) to scan (additional to -i)
amap is a tool to identify application protocols on target ports.
Note: this version was NOT compiled with SSL support!
Usage hint: Options “-bqv” are recommended, add “-1” for fast/rush checks.
7kb.org 原创,如有转载请注明出处 www.7kb.org